Common faults of fixed boarding bridge in operation

怎样找附近卖的学生昆山

contact us

Common faults of fixed boarding bridge during operation

19 / 9 / 16 17:58:37 Click:

If you encounter some faults in the process of using the fixed axle, it is very normal. As long as you know what is going on and solve it, you don't have to worry. So in use Fixed bridge boarding What are the common failures in the process? The following article is a detailed introduction to the content:

one Can fixed boarding bridge be regarded as special equipment?

Fixed boarding axle, whether it is a special equipment, this mainly depends on its rated lifting capacity, if it is in the zero point five Below tons, it can't be regarded as special equipment. Its zero point five Only tons and above can be regarded as special equipment. Therefore, it has a criterion.

two How to determine the circuit in the hydraulic system of fixed landing axle?

For the circuit in the hydraulic system of the fixed axle, specifically speaking, it is:

If in the fixed axle hydraulic system, a certain oil circuit needs higher pressure, but its flow rate does not need to be too large. In addition, the use of high pressure pump can also be considered if the use of high pressure pump is not necessary. Its main components are supercharged cylinder or supercharger.

three What are the faults of the hydraulic system of the fixed axle? What is the reason why the hydraulic fixed axle cannot be lifted with load?

For the fixed boarding bridge system, there are many faults, such as the fixed boarding bridge can not start normally, or its lifting process is not smooth and unstable.

If the hydraulic fixed axle cannot be lifted with load, it is necessary to check whether the oil in the oil tank is sufficient, whether the electrical system is normal, whether the safety valve is normal, and whether there is leakage in the hydraulic system, etc. all of these should be included, and none of them can be omitted.

The above knowledge explanation about the fixed axle and its hydraulic system is very important and basic. Therefore, we should take it seriously and carry out it well. Only in this way can we firmly grasp and apply what we have learned. Moreover, these are of great benefit to the operation and use of the fixed axle.

These are in the use of fixed axle in the process of its hydraulic system may appear failures, I hope everyone knows how to deal with the best.